In a roller holder, cartridge valves are one of four types of valves and they are specifically designed for use with shower rollers. Cartridges have holes that regulate flow and temperature when the handle is turned, and they provide better control than other ropes. In this guide we will learn how to replace a shower cartridge.
1. CARTRIDGE CONTROL ALL ACCESS
No matter what model faucet you have, you must turn off the water supply before you can disassemble it or boil it. It is difficult to know how to remove it.
Although the cartridge is located just behind the handle’s handle, it can be difficult to remove the attachments that hold the handle. If there isn’t a cap covering a retainer screw, look for the Allen nut under the handle. Once you have located and removed the Allen nut, the rest of your attachment will be easy.
2. REMOVAL OF THE HANDLE
Turn the faucet on until it stops flowing. To remove the handle, you can use a wrench. You can remove the screws holding the escutcheon in place and take it out.
3. REMOVE THE RETAINING CLIP
Remove or detach the chrome sleeve if it remains. Use a small screwdriver to remove the clip that holds the cartridge in place.
3. CARTRIDGE REMOVAL
Some cartridges easily removed with pliers. Some faucets require a special pulling bracket (which is usually available at hardware stores or home centers).
Tapering a cartridge means that it operates in a tapered form and not by many grooves.
To ensure that the fitting is secure, turn the cartridge 180 degrees.
4. SUBSTITUTE O RINGS
Check for mineral deposits in cartridges and soak them in vinegar if you can. If the cartridge is in good condition, adjust the O-rings or other worn parts. To clean the O-rings, apply a thin coating of silicone before reinstalling the cartridge. It doesn’t cost anything more.
5. FRESH CARTRIDGE INSTALLATION
Place the new or rebuilt cartouche inside the body of your roller. Slide the clip through and replace the handle. A regular cartridge can be used in older shower valves if the cartridge is not anti-scald.
Some thermostatic systems reduce hot water flow when necessary, while others prevent cold water from flowing by using an anti-scald moisturizer.
Make sure your valve has an anti-scald device. A click can be heard near the faucet indicating that there is an anti-scald valve.
WHAT ARE THE KEY RESPONSIBILITIES?
Resources:
Moen valves can be replaced with replacement parts.
Sometimes they have a cartridge-removal method that allows you to obtain a substitute cartridge before any work begins.
The Tools You Need
- Screwdriver
- Shower Cartridge Puller
- Caulk Gun
- Flathead Screwdriver
- Keep the tools clean by keeping a towel handy
A QUICK REVIEW
- Follow these instructions
- Start by removing the shower handle. A covering plate is usually found with a flathead screwdriver. Keep the handle in place and use the same screwdriver to loosen the screw.
- Cut the plate by removing it from the escutcheon.
- Check to make sure the shower valve is not shut off. If not, turn off the main water supply.
- To remove the cartridge, use a pair or tongs. Do not force it out. It may break if it is removed.
- Apply grease to your replacement cartridge and make sure you close the valve.
- Place the small clip into the new cartridge.
- Apply a silicone bead to the scoop’s back and a foam adhesive to create a waterproof seal.
- Place the cover plate back in place and then manage the tub.
- Turn on the water supply.
Conclusion
You can complete the job with these simple DIY steps. You don’t need to call a plumber or spend a lot of money on it.
